Drainage gullies CRS 600.500
With telescopic pipe and dome grate cover
Connections 110, 160, 200, 250, 315, 400 mm
Drainage gullies with sediment trap DRC (drainage reciever chamber) with diameter of DN 600 [mm]. With telescopic pipe and dome grate cover for installation outside traffic load impact zones, for example in green areas (courtyards, parks, etc.).
- Connections can be made at angles: 0°.. 270°
- Connection DN/OD 110 .. 400 [mm]
- Access hole: DN 500 [mm]
- Sediment trap volume*: 166 [dm³]
*by default, on request it is possible order different sediment trap volumes (or chambers without one at all)
-
Advantages
Long service life (>50 years)
Flexible for movements in soil (no cracking of the chamber)
Water-tightness
Resistant to aggressive environment, no corrosion
The diameter of access hole allows convenient and quick CCTV control and maintenance of sewerage networks
-
Recommended application
For construction in ditches
(for capturing and discharging surface water)In agriculture, forestry, in parks, squares and peat fields
Stadiums and sport complexes
-
Chamber components
OUT 0° DN* 110/160/200/250/315/400
*connections in gullies from DN/OD 110 to 200 [mm] may be formed by use of coupling seal, but connections in gullies above DN/OD 200 [mm] should be formed by built-in connection cup
-
Technical information
Installation depth:
-
Minimum instalation depth: 1.0 [m]
-
Maximum installation depth is up to 6.0 [m], if the ground water level is 2.0 [m] from the surface. If the ground water level is 0.0 [m] from the surface, the maximum installation depth is 5.0 [m], according to the requirements of EN 13598-2 standard
Chamber cover:
-
Cast iron dome grate cover with water throughput area 808 [cm2], h = 60 [mm]
Telescopic section:
-
Telescopic PE smooth-wall pipe DN/OD 500 [mm], height 0.75 [m], corresponds to the requirements of EN 12201-2 and EN 14802 standards
-
Rubber cuff DN 600/500 and rubber sealing ring DN 600 [mm] correspond to the requirements of EN 681-1/A3 and EN 1277 standards
Chamber shaft and base:
-
Height-adjustment corrugated PP double-wall shaft DN/ID 600 [mm] correspond to the requirements of EN 13476-3 and EN 14802 standards
-
Polypropylene (PP) base of chamber, type CR-CT, DN 600 [mm] correspond to the requirements of EN 13476-3 standard
How to create additional connections:
Legend:1 - hole saw
2 - chamber shaft connection seal
3 - socket adapter/chamber connection
4 - sealing ring -
-
Drawings
